Da-Lite Viewshare tensioned Advantage Electrol Specifications download pdf (Page 14)

Surface travel is stopped automatically in the fully opened and closed positions by limit switches that are properly

adjusted at Da-Lite. Should it be necessary to adjust for more or less drop of screen, proceed in the following manner:

Remove two screws to remove access door.

NOTE: Use a screw driver or 5/32" Allen wrench to make adjustments.

Down Limit Adjustment – More Screen Drop

1. Place operating switch in “down” position.

2. When the screen stops, turn the “down” limit knob (Figure 22)

one turn counterclockwise. Test by raising screen surface

approximately two feet, then lower again. Repeat until desired

screen surface position is attained.

CAUTION: Do not adjust for more drop than what was

ordered. At least 11/2 wraps of fabric must remain on the

roller. This screen comes standard with 12" black at the top.

ATTENTION! N'efectuez pas de réglage pour obtenir un

déroulement supérieur à celui commandé. Au moins 1 à 1/2

tour de toile doit être maintenu sur le cylindre. Ce écran est

doté de série d'une bande noire supérieure de 30,5 cm (12

po).

Down Limit Adjustment – Less Screen Drop

1. Raise screen surface approximately two feet above desired level.

2. Place operating switch in “of” position.

3. Turn the “down” limit knob (Figure 22) one turn clockwise. Test by

raising screen surface approximately two feet, then lower again.

Repeat until desired screen surface position is attained.

Up Limit Adjustment – Too Far Out of Case

1. Place operating switch in “up” position.

2. When the screen stops, turn the “up” limit knob (Figure 21) one

turn counterclockwise. Test by lowering screen surface

approximately two feet, then raise again. Repeat until slat bar is

just in case.

CAUTION: Adjusting the limits by more than 6” can cause the

screen surface to lose proper tensioning.

ATTENTION! Le fait d'ajouter plus de 15 cm (6po) aux

interrupteurs de in de course peut faire perdre la bonne

tension à la surface de l'écran.

Up Limit Adjustment – Too Far Into Case

1. Lower screen surface approximately two feet below screen case

opening.

2. Place operating switch in “of” position.

3. Turn the “up” limit knob (Figure 22) one turn clockwise. Test by

lowering screen surface approximately two feet, then raise again.

Repeat until slat bar is just in case.

Appendix A: Screen Adjustment for Type 1 Motor (HV suix in Part Number)

TYPE 1 MOTOR

Has manual limit

adjustments

on end of motor

4-wire connection

TYPE 1 WALL SWITCH

Adjustment Knob “Down”

Adjustment Knob “Up”

Figure 22

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Da-Lite Viewshare tensioned Advantage Electrol Specifications Page 14

Comments to this Manuals